[walkerlakeprinter]

Some more questions! Is the back lower panel supposed to be curved at the top like the back edge of the rumble lid? I bolted the lid in temporarily to see where things fit. I do not have the curved floor pan connected yet, but the lid scrapes on the middle of the top of the lower panel. I'm beginning to think that my home-made wood and steel backup plate is causing the panel to straighten out instead of a gentle curve. Also, the lid is too close to the panel under the rear window. I don't see that there is any way to adjust this. The only thing different from when I dismantled this 10 years ago is a new belt rail.