The Ford Barn - View Single Post - Need dimension of bearing surface axle housing race

RobR'35 · 05-20-2019, 01:17 AM

I've read on here and wrote it down some time ago. Factory 2.061 to 2.063 max. additional wear allowed is minus 5 mils. I don't really get the mils part. I believe it means .005?
Not sure on the wear spec.completely.
I've measured on my car years ago with replaceable sleeves installed before I owned the car. Areas where the bearing didn't ride measured in the spec. I wrote above.

05-20-2019, 01:17 AM	#3
RobR'35 Senior Member Join Date: Dec 2014 Location: Upper Peninsula, Michigan Posts: 604	Re: Need dimension of bearing surface axle housing race I've read on here and wrote it down some time ago. Factory 2.061 to 2.063 max. additional wear allowed is minus 5 mils. I don't really get the mils part. I believe it means .005? Not sure on the wear spec.completely. I've measured on my car years ago with replaceable sleeves installed before I owned the car. Areas where the bearing didn't ride measured in the spec. I wrote above.