The Ford Barn - View Single Post

flatrod · 04-18-2021, 05:02 PM

Austin blower manifold, I intend to put a blower on it, but made the 3x2 to run without the blower. The PVC valve is as I remember is slant 6 because it was the smallest I could find to fit where I have it. Its all a tight fit. There is a baffle under the valley cover so it don't suck up oil. Still have to put a filler/vent pipe in the back of the valley cover. I have a original valley cover but it gets in the way of everything, so I made up a new one.

04-18-2021, 05:02 PM	#8
flatrod Senior Member Join Date: Dec 2012 Location: Anchorage Alaska Posts: 291	Re: PCV For ARDUN Austin blower manifold, I intend to put a blower on it, but made the 3x2 to run without the blower. The PVC valve is as I remember is slant 6 because it was the smallest I could find to fit where I have it. Its all a tight fit. There is a baffle under the valley cover so it don't suck up oil. Still have to put a filler/vent pipe in the back of the valley cover. I have a original valley cover but it gets in the way of everything, so I made up a new one.