Quote:
Originally Posted by Tim Ayers
Hi Gary:
What ever came about that issue with the Navarro heads from CA?
So glad I still have mine that I go from Barney directly.
Thanks,
Tim
|
Hi Tim, every single "negative" issue we found on the Navarro heads couldn't be argued about out at H & H. Mike (Herman) seems to be directly involved in these "new" castings??
The heads would not go on a single build here unless these items were ALL addressed, I do have my doubts about that happening.
Thanks, Gary in N.Y.
P.S. On side note here, we got to use the "Best" head gaskets for the very first time. They are acceptable as far as getting the job done, but working with them on our CNC machined tooling proved to be a "pain", for some reason the mfr left the edge of one of the metal fire-rings "hanging" into one of the head bolt holes, just happened to be the one we use for a "locating" dowel. It was a very minor issue but needed to be addressed before we could go ahead and "pin" the gaskets for the block dowels!