View Single Post
Old 07-12-2017, 09:43 PM   #35
jetmek
Senior Member
 
Join Date: May 2010
Location: albany
Posts: 462
Default Re: Is there a tutorial on king pin r&r

I would highly recommend honing over reaming. It gives a much better fit. I do them that way on my sunnen machine. If you HAVE to use a reamer, DO ONLY ONE BUSHING at a time! if you push both out you cant get the reamer to center on the opposite bushing and the hole will come out crooked.
__________________
engine and component overhauls my specialty!
Website- www.godevilgarage.com
jetmek is offline   Reply With Quote