The Ford Barn - View Single Post

Big hammer · 01-08-2019, 06:24 PM

Some metals will put out poisoning gases! Do some searching on the net. I tried the process and I didn't like the results. I used rebar for anode. I found Evaporust worked better for me, after soaking I clean off the residue with water then I dunk the parts in clean Evaporust and let the parts air dry, which keeps the parts rust free until I can paint the parts.

01-08-2019, 06:24 PM	#16
Big hammer Senior Member Join Date: Jun 2014 Location: Land of Lincoln Posts: 3,131	Re: Removing rust by electrolis...Problem... Some metals will put out poisoning gases! Do some searching on the net. I tried the process and I didn't like the results. I used rebar for anode. I found Evaporust worked better for me, after soaking I clean off the residue with water then I dunk the parts in clean Evaporust and let the parts air dry, which keeps the parts rust free until I can paint the parts. __________________ Don't force it with a little hammer tap, tap, tap get a bigger hammer tap done Last edited by Big hammer; 01-08-2019 at 06:44 PM. Reason: Additional