Quote:
Originally Posted by Jim/GA
Instead of a gasket, I use a small bead of non-hardening gas-proof sealer on the jet where it contacts the cast iron body to ensure a good seal.
|
x2 I use very small smear of Blue Hylpomar on the threads .
Intriguing I have come across one ( and only one) British manufactured Zentith carb wihich did not have a shoulder on either the casting or the jet and someone had used a gasket... I have not seen any other Zenith like that ( no matter where they were made) but I am still not sure if this was a backyard bodge or if it came out of the factory like that.