Thread: Tight engine
View Single Post
Old 02-17-2018, 10:54 PM   #15
Simonpie
Senior Member
 
Join Date: Mar 2015
Location: Portland Or
Posts: 137
Default Re: Tight engine

3 hours is a pretty respectable amount of run time. Dry rings can have a lot of drag, so I agree with the oil in the cylinder ideas. When you pulled the pan, did you change the rope seal? I've seen those seals cause a lot of drag on the pulley. No real cure for it other than to force it to start and run it for a while. It breaks in over about 1/2 hour of running. You'll know it is good when the pulley stops getting smoking hot.
Simonpie is offline   Reply With Quote