The Ford Barn - View Single Post - For those with machining experience. Sleeve fitting??

Mart · 11-20-2019, 10:08 AM

Sponsored Links (Register now to hide all advertisements)

Thanks for the pointers fellas. I'm part way through getting the studs out. I'm not going to rush into anything. I do have a block that is definitely scrap due to extensive cracking. It is tied up right now, but once it becomes available, I'll try the boring bar and see how it turns out. If it goes well I just might try it for real on the 99 motor.

Thanks again, if and when I am ready to try it I'll ask for more specific boring help.

Mart.

11-20-2019, 10:08 AM	#6
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,752	Re: For those with machining experience. Sleeve fitting?? Sponsored Links (Register now to hide all advertisements) Thanks for the pointers fellas. I'm part way through getting the studs out. I'm not going to rush into anything. I do have a block that is definitely scrap due to extensive cracking. It is tied up right now, but once it becomes available, I'll try the boring bar and see how it turns out. If it goes well I just might try it for real on the 99 motor. Thanks again, if and when I am ready to try it I'll ask for more specific boring help. Mart.