The Ford Barn - View Single Post

John · 01-15-2020, 11:43 AM

A good machine shop can make a coupling and then weld the top of of the seven tooth shaft shaft to the lower end of the two tooth shaft. Just be sure to get the correct overall length.

01-15-2020, 11:43 AM	#2
John Senior Member Join Date: May 2010 Location: Richmond, VA Posts: 189	Re: steering sector A good machine shop can make a coupling and then weld the top of of the seven tooth shaft shaft to the lower end of the two tooth shaft. Just be sure to get the correct overall length.