View Single Post
Old 01-15-2020, 05:13 PM   #28
Lawrie
Senior Member
 
Lawrie's Avatar
 
Join Date: May 2010
Location: Qld, Australia
Posts: 3,356
Default Re: Vibration - rumble

I can tell from experience that you will need a really bad rear wheel bearing to make a noise,I had to run one one in the 33 far worse than that ,I think from memory did two big trips total of about 13000klms.But, they made a scraping noise when rurning as the brake drum draged on the backing plat , but none straight ahead.
Look at the U/joint ,carrier bearings ,centre bearings or front drive shaft roller.
Lawrie
Lawrie is offline   Reply With Quote