View Single Post
Old 05-17-2019, 05:34 PM   #11
BRENT in 10-uh-C
Senior Member
BRENT in 10-uh-C's Avatar
Join Date: May 2010
Location: Eastern Tennessee
Posts: 9,075
Default Re: Upper Steering Column Bushing

Originally Posted by redmodelt View Post
The whole part is the bushing, not just the woven lining. Think most just replace the whole part when they restore the unit. Maybe someone has replaced just the woven part. I suggest you reask the question with WHAT you are looking to do in the title.

Mark, I agree, --and I am not sure how to get the woven material into the recess with the steering shaft still installed. If you must take the upper bushing unit out (...along with spark & throttle rods) it kinda seems it would be best to replace the whole unit. Maybe an inside knurling tool might add some life to the worn bushing, but again that sure seems like a lot of work.

BRENT in 10-uh-C
...(...Finally Updated!! )

BRENT in 10-uh-C is offline   Reply With Quote