Quote:
Originally Posted by 19Fordy
Phillip: I tighten the anti chatter rod nuts enough to take out the play.
Also use BLUE Locktite.
Then double nut them if possible. DO NOT use lock washers.
There is no specific torque as far as I know.
|
The ends that loosened up were not the forward adjustable ends but the rear frame attachments. The front ones are hex, not square, and seem plenty tight. I also found the front motor mounts were major loose. From underneath, there was only rubber and a nut, no steel washers on either side. I could move the bottom rubber up and down 1/4"!! New mounts coming. How much chattering does that cause? That motor could move up and down 1/4" and forward and back 1/2".