The Ford Barn - View Single Post - If you need a haul for your project - parts

trulyvintage · 09-07-2010, 12:04 AM

Moving on - see my next post

Starting Tuesday, September 7th

20 feet of room with 6000 pound capacity available
for Ford transport from Rosamond, CA to east Albuquerque, NM

Here is my route:

@ http://mapq.st/h/7-Vk4H

September 10th

Limited room for parts transport available east
from Albuquerque, NM to Clarkton, MO

Here is my route:

@ http://mapq.st/h/1-4g2K

September 14th

20 feet with 6000 pound capacity available from
Clarkton, MO up to Rochester, MN for Ford transport

Here is my route:

@ http://mapq.st/h/6-rINo

Call Jim
(260) 804-6695

09-07-2010, 12:04 AM	#80
trulyvintage Senior Member Join Date: May 2010 Location: Direct Enclosed Transport Since 2006 Posts: 4,160	Moving on - see the next post Moving on - see my next post Starting Tuesday, September 7th 20 feet of room with 6000 pound capacity available for Ford transport from Rosamond, CA to east Albuquerque, NM Here is my route: @ http://mapq.st/h/7-Vk4H September 10th Limited room for parts transport available east from Albuquerque, NM to Clarkton, MO Here is my route: @ http://mapq.st/h/1-4g2K September 14th 20 feet with 6000 pound capacity available from Clarkton, MO up to Rochester, MN for Ford transport Here is my route: @ http://mapq.st/h/6-rINo Call Jim (260) 804-6695 __________________ Click Here To See Where I Am Today What My Actual Customers Say Click Here Click Here To See Vehicles I Have Hauled Last edited by trulyvintage; 09-16-2010 at 08:05 AM.