The Ford Barn - View Single Post

danliveshere · 02-16-2020, 05:45 AM

Thanks guys. I’m away at the moment but when I get home next week I’ll look up my 35/36 book, it’s got so much information in it I must admit I forgot to look in it. Good tip regarding the 35 filler. I was going to remove it anyway to put a new lead washer in it so I’ll look at my 35 tank. So does that mean the tail light harness get routed in a different spot to the fuel line? If you use the running board bolts for the clamp then the fuel line is right in the corner and the wiring harness in the middle of the lower half of the frame using the push on clamps?

02-16-2020, 05:45 AM	#5
danliveshere Senior Member Join Date: Jul 2010 Location: Cairns , Australia Posts: 748	Re: 1936 fuel line and wiring loom clamps? Thanks guys. I’m away at the moment but when I get home next week I’ll look up my 35/36 book, it’s got so much information in it I must admit I forgot to look in it. Good tip regarding the 35 filler. I was going to remove it anyway to put a new lead washer in it so I’ll look at my 35 tank. So does that mean the tail light harness get routed in a different spot to the fuel line? If you use the running board bolts for the clamp then the fuel line is right in the corner and the wiring harness in the middle of the lower half of the frame using the push on clamps?