The Ford Barn - View Single Post

russcc · 06-23-2017, 05:48 PM

Excellent post on Rumbleseat's grease it technique. Makes a lot of sense, and 200,000. miles is proof positive. The real issue is what you start with. I suggest you check with Ft Wayne clutch to see what they have. I got an Aetna TO bearing from them a month or so ago, Aetna has been in biz for years, and makes this and other bearings in the IL, USA. Stamped USA, and wrapped in oil paper as all bearings should be. The other junk is a plastic sleeve.

06-23-2017, 05:48 PM	#4
russcc Senior Member Join Date: May 2010 Posts: 2,871	Re: Throwout bearing choice Excellent post on Rumbleseat's grease it technique. Makes a lot of sense, and 200,000. miles is proof positive. The real issue is what you start with. I suggest you check with Ft Wayne clutch to see what they have. I got an Aetna TO bearing from them a month or so ago, Aetna has been in biz for years, and makes this and other bearings in the IL, USA. Stamped USA, and wrapped in oil paper as all bearings should be. The other junk is a plastic sleeve.