The Ford Barn - View Single Post

D. Jones · 08-10-2018, 04:23 PM

If you put some grease in flutes of the tap and go a very little bit then back out, clean and re-grease and go again you should catch all of the metal the tap cuts. Some might disagree but I've done this a few of times and not had any problems.

Just my $0.02 worth.

08-10-2018, 04:23 PM	#5
D. Jones Senior Member Join Date: Jan 2013 Location: Bend, Oregon Posts: 514	Re: UnStuck Block/Full Flow If you put some grease in flutes of the tap and go a very little bit then back out, clean and re-grease and go again you should catch all of the metal the tap cuts. Some might disagree but I've done this a few of times and not had any problems. Just my $0.02 worth.