The Ford Barn - View Single Post

Wick · 09-23-2011, 02:10 PM

Yea,Brent I learned alot! I was allways told 10% motor 10% Driver 80% Kart.
Milling Heads,profileing Cams,checking lifters,Flow testing carbs and weighing every moving part! it all added up. Also make sure when your wide open that the carb is wide open too! This can all be used on the Model A.
Wick

09-23-2011, 02:10 PM	#23
Wick Senior Member Join Date: May 2010 Location: Gwynn's Island Va Posts: 1,386	Re: Milling a head for compression? Yea,Brent I learned alot! I was allways told 10% motor 10% Driver 80% Kart. Milling Heads,profileing Cams,checking lifters,Flow testing carbs and weighing every moving part! it all added up. Also make sure when your wide open that the carb is wide open too! This can all be used on the Model A. Wick