Quote:
Originally Posted by 40larry
Mike:
Looks good. I can see that heater switch is located incorrectly. Check the factory photo in Towne's book on page 40 and you see it located slightly left of the throttle rod on bottom of dash. Also your tailpipe should be a 91C part which ends several inches after the rear hanger. You can see this on the factory photo shown in the Mack Hils book. This will be easy to fix by cutting off the excess length...........Larry
|
Larry, this is a
very early truck according to the serial number. The only hole for the heater switch was to the left of the steering column.
The tail pipe, as well as the rest of the exhaust system was NOS - purchased through Carpenters.
I will double check the length of the tail pipe once the bed, etc. is in place. As always, your advice is much appreciated. Much of what I have done was made easier because of your help.