Re: My new project 1928 Ford!!!!!
It has been a while since I posted on this side of the forum. I have made some progress on this project slowly but shurely. Pictures are showing where I had to shorten the floor board due to the fact that this body was narrowed and shortened as well. Also this past weekend I was able to do more work I had located a pillar post from a 1929 Briggs which I had to slice in half so that one piece would be use for the left side and the other for the right side and would be welded to the rear quarter panel. Both rear quarter panels were made out of the two rear doors and both were shortened down to 12 inches in width. As you can see from these pictures.
Thanks
Frenchy
|