Re: Hood Ornament for 39 Deluxe
I had the same fitting problem of my DeLuxe hood ornament not fitting the curvature of the hood after I had it rechromed.
What happens during the chroming process is that the two ends of the ornament actually "pull in" towards towards each other making the curvature radius smaller.
I ended up using a Dremel tool with a small grinding wheel to enlarge the radius so ornamemnt would fit. Took a long time and patience to do as you don't want to scratch the visible chrome. Cover it with several layers of masking tape.
If the plater had properly put a brace between the two ends during plating this would not happen. Makes one wonder about the plater's knowledge of the physics of the plating process. You would think a plating business would know this in advance.
|