View Single Post
Old 01-02-2019, 01:14 AM   #11
expavr
Senior Member
 
expavr's Avatar
 
Join Date: May 2010
Location: Hansville, WA
Posts: 776
Default Re: 1940/41 Ford 1/2 Ton Windlace installation?

As I recall on the 40 Tonner I used tacks with a spiral thread on the shank which were driven through the fringe on the welting into those holes to hold it to the sheet metal. The tacks were included in the LeBaron Bonney interior kit. The only place I used contact cement was in the center of the cab ceiling to hold the wood block that the headliner is screwed to in order to keep it from sagging.
expavr is offline   Reply With Quote