Quote:
Originally Posted by jwmckenzie
I understand that Brookfield has the Gas Light dies and is doing the stamping. Gas Light is then putting the wire in. Brookfield guy told me this at Carlisle this last fall.
I expect the same problems exist as always.
|
Thanks JW. I notice that a lot of those restoration programs on TV point out that most aftermarket sheet metal is rarely a bolt-on situation. Most after market stuff has to be massaged to fit.
I would think that I could make pattens from my old fenders and transfer them to the new ones to simplify the fitment. I’m just going to go to a body shop to fit them as I don’t have the skill to do it myself.
David Serrano