The Ford Barn - View Single Post

B-O-B · 10-06-2012, 09:24 AM

[Story said the engine was mounted on truck engine pads & a 3/4 ton truck front spring was installed.

QUOTE=Bruce Lancaster;511035]Austin...he was covered in one of the early small magazines while in school for a drag car with a completely homemade injection system on a Ford six. Injection was through a hole in the intake valve seat, pressure control had a lot of parts from an oil furnace!
More recently he has manufactured Ardun, 337, and Lincoln V-12 manifolds.[/QUOTE]

10-06-2012, 09:24 AM	#13
B-O-B Senior Member Join Date: May 2010 Location: Ft Mohave,Az Posts: 1,987	Re: Flat 337 Lincoln in a '39 CVS [Story said the engine was mounted on truck engine pads & a 3/4 ton truck front spring was installed. QUOTE=Bruce Lancaster;511035]Austin...he was covered in one of the early small magazines while in school for a drag car with a completely homemade injection system on a Ford six. Injection was through a hole in the intake valve seat, pressure control had a lot of parts from an oil furnace! More recently he has manufactured Ardun, 337, and Lincoln V-12 manifolds.[/QUOTE]