The Ford Barn - View Single Post

The Master Cylinder · 10-13-2019, 12:23 AM

I think you would have to change the height of the engine quite a bit to change the caster very much. It has been awhile but I seem to remember you have to lower the radius rod mounting ~¾" to change caster 1° at the spindles.

10-13-2019, 12:23 AM	#11
The Master Cylinder Senior Member Join Date: Aug 2012 Posts: 887	Re: ?? Float a Motor rear mount I think you would have to change the height of the engine quite a bit to change the caster very much. It has been awhile but I seem to remember you have to lower the radius rod mounting ~¾" to change caster 1° at the spindles. __________________ The Master Cylinder Enjoying life at the beach in SoCal...