The Ford Barn - View Single Post

Tinker · 10-23-2019, 09:35 PM

Do you have a drop axle also? The weight of the later engine might be lowering things a bit also.

Might think about a drop steering arm. Mods need mods. Drag connects to one spindle (across the car), "tie" rod runs to the other spindle (spindle to spindle). I think most are on board there.

You might have drop spindles for the tie rod. Which why they clear but your steering arm (drag) may not be.

Just a thought.

.

10-23-2019, 09:35 PM	#56
Tinker Senior Member Join Date: May 2010 Location: MN Posts: 7,053	Re: 36 Ford drag link orientation question Do you have a drop axle also? The weight of the later engine might be lowering things a bit also. Might think about a drop steering arm. Mods need mods. Drag connects to one spindle (across the car), "tie" rod runs to the other spindle (spindle to spindle). I think most are on board there. You might have drop spindles for the tie rod. Which why they clear but your steering arm (drag) may not be. Just a thought. .