[Curt in AZ]

Originally Posted by mrfliboy

Got the Booth almost completed, (done) hoping to lay some paint down this weekend. Kinda hard to show the size, basically 12' x 8'.

Picked up my 2K Epoxy, gun, sandpaper and ready to paint.

Did some rust treating with KBS RustBlast, like it much better than Ospho. Seemed to work a lot faster.

Underside of running board was wire brushed, degreased, Rustblast treated, scrubbed during this time with scotchbrite pad for 1 hour. Rustblast wiped off, than rinsed with water. Compressed air dried. 2K epoxy sealer applied with gravity feed gun.

High build primer applied 3 coats

Got my work cut out for me for the next few winter months. LOL

Wow, what an amazing illustrated chronology of the build. How are you moving air through the booth? Thanks.