Re: Thermocure and new water pump
Most of the rust is always in the block around the rear 2 cylinders. Have seen enough to fill a 2# coffee can when dry, stripped block, turned upside down with head off. That was after flushing. Use a segment if old speedo cable and long screw drivers to loosen up the solid mass. Any cure in a can good enough to clean out the block would destroy a radiator in minutes with rust chunks and could damage the block as well. In either case, when all is said and done a coolant filter in the upper hose should be used because flakes will circulate, looking for a new home. Catch them on the first lap around and before they get to the radiator.
|