View Single Post
Old 08-11-2020, 11:47 PM   #1
Otterby
Junior Member
 
Otterby's Avatar
 
Join Date: Oct 2017
Location: Casper, WY
Posts: 27
Default Drag Link Question

Iím installing a NOS drag link in my Ď48 Super Deluxe. The fixed ball joint end included a flat washer and a rubber washer. How do these set on the ball joint stud. Does the flat washer sit against the ball joint or against the spindle arm? I believe that itís supposed to sit against the ball joint but being flat itís going to let the grease escape easily. Or will it conform to the ball joint as the nut is tightened?
Otterby is offline   Reply With Quote