Maybe, this time.
First picture is of an Eckhold Piccolo machine that was used to 'tip' shrink the corners inward onto themselves.
No slip rolls were available, so I inserted a go-cart tire into the upper holder of a smaller english wheel and rolled the sides and corners with it, then smoothed the curves in a larger, more rigid english wheel.
As with the rear body panels, the parts still have to be welded together and metal finished.
3wc42 017.jpg
3wc42 041.jpg
3wc42 042.jpg
3wc42 044.jpg
3wc42 045.jpg
3wc42 046.jpg
3wc42 047.jpg