Quote:
Originally Posted by Ol' Ron
Pete, before I got so involved with Flatheads, I spent a great deal of time porting SBC , Olds and Y block heads. Now your telling me that you can make a flathead port flow as much. At present I plan on filling the water jacket above the port with Devcon liquid steel, si I can open up the entrance to the bowl. I then plan on welding a small plate to the guide to direct the flow awayfrom the rear of the bown. I also plan on using a 1.72 valve. The engine in the Hydro was similar except it didn't have the diflector plate. Which I think was your idea. also JWL made a set of guides which did a similar function. Now after all this the flow has to go out of the valve and make a 145 degre turn into the cylinder. I kinda think, this iz a bigger problem. I also spend allot of time modifying the cylinder heads to provide a better flow. The engines run pretty good, but not a hell of alot better than stock.
|
"Now your telling me that you can make a flathead port flow as much."
Yes, I said, "THE PORT", not the whole path to the cylinder. That is not going to happen. Also, I said a "STOCK" SBC port.