Thread
:
H&H Model A motor thrust bearing issue
View Single Post
03-13-2019, 12:49 PM
#
5
Jim Brierley
Senior Member
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,089
Re: H&H Model A motor thrust bearing issue
Benson makes a good point! Some engine builders use only the lower half of the thrust bearing, because it is much easier than making a full-circle bearing. IMO this is not adequate, and they do wear out!
Jim Brierley
View Public Profile
Send a private message to Jim Brierley
Find More Posts by Jim Brierley