View Single Post
Old 06-18-2021, 07:18 PM   #1
Fatheads4ever
Member
 
Fatheads4ever's Avatar
 
Join Date: May 2021
Location: Auckland New Zealand
Posts: 48
Default Ford 59A pcv valve... errr

Hi All.. now that my engine is in bits waiting for its new pistons etc, I've been pondering with the idea of installing a PCV valve.
Here's what I'm proposing to do.

Drill and tap the intake manifold to fit the valve.
Blank off the sump vent.
The crank case will be able to draw air through the fuel pump riser cap.
I'll be able to plumb the pcv valve from the manifold to the base of the carb where the vacuum wiper port is. This is blanked off as I have fitted a electric wiper.
I could also install a old oil filter housing in the vacuum line to basically scrub any potential muck before entering back into the combustion chambers.

What do you think?
Fatheads4ever is offline   Reply With Quote