The Ford Barn - View Single Post - 8BA Flywheel/Clutch....I've Read TOO Much

Mart · 06-22-2018, 06:39 AM

The diagram bugs me a little. The .500 dimension is not correct. It should be .500, but measured radially between the two holes, in other words, the radius that the outer set of holes is on is .500 bigger than the radius of the inner holes.

Call me picky, but That's how I see it.

Mart.

06-22-2018, 06:39 AM	#14
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,744	Re: 8BA Flywheel/Clutch....I've Read TOO Much The diagram bugs me a little. The .500 dimension is not correct. It should be .500, but measured radially between the two holes, in other words, the radius that the outer set of holes is on is .500 bigger than the radius of the inner holes. Call me picky, but That's how I see it. Mart. Last edited by Mart; 06-22-2018 at 06:45 AM.