The Ford Barn - View Single Post

garyjohn · 12-11-2019, 07:38 PM

I saw one at a car show a few months ago. I asked the guy about it and how it was done. Basically you re-drill a model a fly wheel adapter and bolt it to the engine and drop it in using the stock rear motor mounts and every thing behind is model A. I am not sure about the front mount, probably have to manufacture one. The fan does sit quite low be he said it did seem to be adaqit.

12-11-2019, 07:38 PM	#2
garyjohn Senior Member Join Date: May 2012 Location: Big Pine,CA Posts: 161	Re: pinto engine on model A I saw one at a car show a few months ago. I asked the guy about it and how it was done. Basically you re-drill a model a fly wheel adapter and bolt it to the engine and drop it in using the stock rear motor mounts and every thing behind is model A. I am not sure about the front mount, probably have to manufacture one. The fan does sit quite low be he said it did seem to be adaqit.