View Single Post
Old 03-15-2018, 06:59 PM   #16
TJMack
Member
 
Join Date: Mar 2017
Location: Venice, Fl and Marcy, NY
Posts: 93
Default Re: Nu Rex breaker plate points problem.

Quote:
Originally Posted by Benson View Post
The reason for screwing cable in only a few turns is that if you turn too far the plate that the cable end contacts can be bend so that it shorts out on dist housing. This shorts cable to ground making it appear that the points are closed all the time.

This happens with the stock setup with condenser in stock position, especially if you are using REPRO lower plate where the metal is thinner than FORD parts.


That makes sense. Thanks for the explanation.
TJMack is offline   Reply With Quote