View Single Post
Old 08-07-2020, 02:19 PM   #29
Chris Marshall
Senior Member
 
Chris Marshall's Avatar
 
Join Date: May 2010
Location: Overbrook, Ks
Posts: 158
Default Re: Mallory sbc to 8BA 4 lobe cam issues

Here's photos of the Magspark and Voltmaster coils I have. Mine is not nearly as clean as the one solidaxle shows. The primary connection tabs have a very distinct "P" and "R" stamped in them. Do these have any meaning?

The Voltmaster uses the exact same casing as the Magspark. The two primary terminals are repurposed as "+" and "-". The Magspark Ignition terminal is covered with a small plastic cap on the Voltmaster.

Denny, I'd certainly be interested in a copy of any Magspark information you might have. I have a "not fordbarn friendly" project that would be perfect for this setup. I'm not sure my coil is good though. It's leaking alot of tar. Possibly Skip can rewind these.
Attached Images
File Type: jpg Mallory1.jpg (46.7 KB, 19 views)
File Type: jpg Mallory2.jpg (32.1 KB, 17 views)
File Type: jpg Mallory3.jpg (36.3 KB, 17 views)
File Type: jpg Mallory4.jpg (50.6 KB, 19 views)
Chris Marshall is offline   Reply With Quote