Quote:
Originally Posted by Stretch Cab
I'm sure I will need a spreader to get it back together.
|
Yes and no. If you want to install the spring as an assembled unit you about need a spring spreader. You can take the spring apart (not a bad idea anyway if your cleaning everything up). It is not to difficult to install just the main leaf to the rear axle. Then the other leaves can be placed on top of it using a good quality piece of all-thread. Tighten the all-thread to compress the springs. As it starts to come together, there is a lot of stored energy in there! Several c-clamps on the spring leaves help. Tighten the all-thread a bit, then the c-clamps, etc. When fully compressed, remove the all-thread and install the proper center bolt.
Same procedure in reverse works to disassemble the spring.