Quote:
Originally Posted by Beater
well I turned it upside down and got the wire wheel and polished the heck out of them think they will be ok guess we will see. greased them and stated putting things back together. waitin on a HC head now
my lil make do shop is prity old school
 |
I would replace that aluminum hub centered Cloyes timing gear as if the fiber gear is not loose now it will be.
Also as posted above by someone do NOT put heat on your crank gear unless you want to do you babbit as well.
Bad advise from some posting so beware.
As was noted the Kr wilson puller for replacing the heat when the crank is in is the best . Also the 6306 installer makes it a piece of cake to install .
Experience, the right tool for the job, and being careful is key.
If the crank is out you can use a common puller with the crank nut used as your center.
Larry shepard