View Single Post
Old 03-22-2019, 01:08 PM   #8
duke36
Senior Member
 
Join Date: Jun 2015
Posts: 1,063
Default Re: Gas shutoff valve

If you don't mind a non stock setup, what I used to do with inside shutoff valves was drain the fuel, remove the valve, install a common brass elbow in the tank bottom to receive the stock gas line/ fittings. Then measure for a 1/8" ball valve from a home supply store, etc.and remove the small line section out. Install compression fittings. I've never had a leak and fuss as common with the orig. valves. The ball valves should be good for ethanol gas.
duke36 is offline   Reply With Quote