The Ford Barn - View Single Post

Tom Wesenberg · 12-03-2014, 03:50 PM

John, the correct router bit is hard to find, but I finally found mine at Tried and True Tools in the Twin Cities. I then made my own router table. As Rusty said the boards need to be run though from each side to keep them accurate. I'm making 3 sets, which I started about 12 years ago, then set them aside to do other projects. I bought nice 11/16" Maple boards from Menards.

12-03-2014, 03:50 PM	#11
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: 28 floorboards progress John, the correct router bit is hard to find, but I finally found mine at Tried and True Tools in the Twin Cities. I then made my own router table. As Rusty said the boards need to be run though from each side to keep them accurate. I'm making 3 sets, which I started about 12 years ago, then set them aside to do other projects. I bought nice 11/16" Maple boards from Menards.