Re: Removing head
Since you say you have all the head bolts out, I am guessing you mean the head studs are out. I then use a wide putty knife and judiciously tap it in at all four corners, spraying WD-40 into all areas I get the putty knife to go into. It took me all afternoon to get the last one off, but it finally did come loose. I try to keep the putty knife between the head and the gasket in case something goes very wrong, then I haven't harmed the block, just the head. Kroll and any of your favorite penetrating oils will be useful. I use WD-40, cheap and any hardware store has it, even the grocery stores. Good luck!
|