The Ford Barn - View Single Post

hardtimes · 10-30-2014, 12:13 PM

Hey Tod,
Thanks for the good/informative information. Do not know your work /job, but was thinking ...if it would be most accurate/correct bore when done first time. No problem

.

10-30-2014, 12:13 PM	#10
hardtimes Senior Member Join Date: May 2010 Location: South California Posts: 6,190	Re: New block machining. Hey Tod, Thanks for the good/informative information. Do not know your work /job, but was thinking ...if it would be most accurate/correct bore when done first time. No problem .