View Single Post
Old 09-10-2014, 12:05 PM   #6
Tom Wesenberg
Senior Member
 
Tom Wesenberg's Avatar
 
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Default Re: 060 on block and pistons

Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by Slik View Post
Thanks for the replies.
Tom - you highlighted my "flood with ATM" - was that good or bad ?
I'll put it this way, if I can keep from dumping a lot of money into getting this running, my wife will be much happier. At this point I am committed to getting this running right - not looking to be sloppy but at the same time trying to be somewhat prudent in where the money goes too.
It was a joke...........ATM is for money, and ATF is the automatic tranny fluid you had in mind.

Mike, I removed the head from a 1929 Chevy engine years ago and found someone bored the cylinders .030" oversize but used the stock pistons. I'll bet that engine had some piston slap.
Tom Wesenberg is offline   Reply With Quote