The Ford Barn - View Single Post - T-5 to flathead won't shift into gear with engine running.

Init1 · 08-17-2014, 12:53 PM

My newly installed T-5 won't shift. Shifts fine with the engine not running.
Using 10" S-10 disc, stock ford throw out, New ford long arm pressure plate
Late flattie with hogs head and and 1" adaptor plate.
The disc is releasing.
Everything bolted up normally so I did not cut any off the end of the trans input shaft. Could that cause the problem? Anybody got an idea?

08-17-2014, 12:53 PM	#1
Init1 Senior Member Join Date: May 2010 Location: Oregon City, Oregon Posts: 208	T-5 to flathead won't shift into gear with engine running. My newly installed T-5 won't shift. Shifts fine with the engine not running. Using 10" S-10 disc, stock ford throw out, New ford long arm pressure plate Late flattie with hogs head and and 1" adaptor plate. The disc is releasing. Everything bolted up normally so I did not cut any off the end of the trans input shaft. Could that cause the problem? Anybody got an idea?