No offense intended, senor. I have been assisting a daughter restore a 1720 home for the last year plus up in Mass., so I haven't been on this forum for quite some time. A lot of new names to me. In past years, there was some detailed info dispelled as gospel, but until you learned who the players were, one tended to confirm some of the specs cited.
I never even thought to look in Bratton's catalog. I will dig out the torque wrench and give 80 ft. lbs. a shot. I originally torqued the hubs to "very darn tight," but certainly not to the 100 ft. lb. level.
Which is worse: the Houston heat and humidity, or the Dallas heat? I think that Houston takes the cake. But, this is why I started this restoration some ten years ago up in New Jersey.
Thanks for the comments.