The Ford Barn - View Single Post

Drive Shaft Dave · 08-03-2014, 10:20 PM

To check this I would use an analog VOM , selected to the 20 amp DC. Disconect the out put wire from the cutout, then connect one wire from the meter to the cutout out put and the other lead to the wire you took off. Start and run at fast idle and see what you get.

08-03-2014, 10:20 PM	#2
Drive Shaft Dave Senior Member Join Date: Dec 2011 Location: New hope Minnesota Posts: 742	Re: Checking the ammeter To check this I would use an analog VOM , selected to the 20 amp DC. Disconect the out put wire from the cutout, then connect one wire from the meter to the cutout out put and the other lead to the wire you took off. Start and run at fast idle and see what you get.