[Tod]

We had to knock off a little early today because my grandson is "graduating" from pre-school or kindergarten, or whatever it is, this evening. Since we shut down production early I had some time to work on the back end of the block. I was able to get all the holes drilled and tapped and set a flywheel housing against it. Looks good at first hurried glance. I had to leave so I will have to finish up in the morning and bolt it on. That will be the last part to bolt on before moving on to the cam, oil galley, and then the bottom.

I'll send out a round of pics when everything is bolted on including a head.

Tod