[Tod]

Today, in between production, and at the end of the day, I was able to finish up the side water-outlet face and bolt on a borrowed water-neck. Looks good. Then I faced the valve cover side and drilled/tapped all those holes. I need to get some bolts to fasten everything on but I did put studs in and fasten on an intake and one of my cast iron tube headers. Everything looks good on that side also. So far, so good.

Sorry it is taking so long but my primary use of machines is production. It is time consuming to put something in without fixturing and plow through it. It will get there. Please be patient.

Tod