The Ford Barn - View Single Post

Tod · 03-30-2014, 01:59 AM

I tried to PM a few of you but my messages were lost because it said I was not logged in. But I sure was logged in, to read a couple of PMs to me. So, I 'll have to try it again some time. I appreciate the "encouragement" on both forums, PMs, and emails. With the block sitting in one of my vertical CNCs being cut on you better believe nobody is going to dissuade me. I'll send pics to those of you who are discussing things with me privately.

Tod

03-30-2014, 01:59 AM	#45
Tod Senior Member Join Date: Mar 2014 Location: Salem, Ohio Posts: 1,058	Re: New Block thread on H.A.M.B. I tried to PM a few of you but my messages were lost because it said I was not logged in. But I sure was logged in, to read a couple of PMs to me. So, I 'll have to try it again some time. I appreciate the "encouragement" on both forums, PMs, and emails. With the block sitting in one of my vertical CNCs being cut on you better believe nobody is going to dissuade me. I'll send pics to those of you who are discussing things with me privately. Tod